QUICK MOLD CHANGE SYSTEM

快速换模的好处

BEFORE AFTER IMPORTING QUICK DIE CHANGE

BEFORE

Manual Operation

While Die/Mold changing, it takes long time and manpower to tighten.

The tightening force will be different by different operators.

Operators waste much manpower, increased injury happened.

No alarm notification while the screws are loosing.

AFTER

Automation

Only touch the buttons on the control panel.

The clamping force is the same. Increased safety.

By control panel, operators save manpower and decrease injury happened.

With alarm device, the machine will stop immediately.

COMMERCIAL BENEFITS OF IMPORTING QUICK DIE CHANGE

DIRECT BENEFITS

Reduce die/Mold change tim

Multiple small quantities

Reduce inventory

Quality improvement

Reduce labor costs

INDIRECT BENEFITS

Dies Standardization

Press Standardization

Increasing Operational Safety

Achieve rapid production and marketing

Improving factory environment

SYSTEM SelectION

Our company can adapt to the user's habits and tailor the most suitable quick changeover system and fully automatic die change trolley system according to customer needs to help you complete intelligent manufacturing.

MOLD INTO THE LEGEND
WHEN THE MOLD IS PLACED VERTICALLY
WHEN THE MOLD IS PLACED HORIZONTALLY

>> Basic type selection		>> Clamp clamping force calculation		>> Upper and lower molds		>> Number of clamps
There is a "U" groove design on the edge of the mold, using the TX type No "U" groove design on the edge of the mold, using TY type		Clamp total clamping force = punching capacity 20%		(Upper mold clamping force): (lower mold clamping force) = 3:2 (single clamp clamping force) = (upper or lower die clamping force) / number of clamps		Depending on the size of the mold and the tonnage of the punch output

Bolt specification	M16	M18	M20	M24	M30	M38
Clamping force	4	4	6	10	16	20

* The clamping force of the upper clamp should be corrected according to the actual operation, and the thickness of the clamping die must be standardized to facilitate the use of the clamp.

>> Reference reference

Depending on the tonnage of the press, choose DL type (oil pressure type) or DR type (spring type), and also consider the weight of the mold and the length of the desired lifter.

>> Reference reference
· Lifter length · Maximum load weight
· Piping accessories · Modeling ability
· U Slot size

CASE VIDEO